Bfvanilla.zip -

: Sew a "bar tack" (a wide zigzag stitch in place) across the teeth at the bottom end.

: For nylon coil zippers, lightly singe the raw edges with a lighter to prevent fraying. BFVanilla.zip

: Hold both sides of the tape so the teeth are level. : Sew a "bar tack" (a wide zigzag

: Slide the right side into the mouth at a slight angle. BFVanilla.zip

Since you are creating a custom long piece, you must secure the ends to prevent the slider from flying off:

: You can crimp on metal top stops or simply sew several loops of thread over the last few teeth on each side.

: Measure your project and cut the zipper tape about 2 inches longer than the actual opening.